The Spiral Barrel Machine forms metal strip into cylindrical barrels with a continuous outside lock seam. Designed for roll-up door production, it combines strip feeding, spiral forming, cutting and supported outfeed in one machine.
This machine turns metal strip into cylindrical barrel shells with a continuous outside lock seam. The formed barrel travels onto a roller outfeed, where operators can inspect the seam and handle the finished shell before the next assembly step.
It is designed for roll-up door manufacturers producing barrel components from coiled strip. End plates, shafts and other fittings are added according to the required door design.
The metal strip is guided from the coil into the forming section.
Forming tooling curves the strip into a cylinder as adjacent turns join along an outside spiral lock seam.
The barrel moves onto the roller outfeed for inspection and handling before cutting and assembly.
The machine forms a cylindrical barrel from strip in a continuous process.
The visible seam runs along the outside of the barrel for inspection.
Rollers support the long cylindrical shell as it leaves the forming section.
Forming speed can be set within the specified 0–40 m/min range to suit the production setup.
The machine produces the cylindrical barrel shell used in a roll-up door assembly. End plates, shafts, door curtains and other fittings are produced or fitted in separate steps. Barrel diameter, finished length and end fittings should be matched to the door design.
It forms the spiral barrel shell. The curtain, end plates, shaft and other components require separate production or assembly steps.
The finished diameter depends on the forming tooling and setup. Send the required diameter or a barrel drawing so the configuration can be checked.
The supplied specification lists a 137 mm strip width and a 0.4–1.0 mm thickness range. Material and coating should be matched to the required barrel design.
Send the required barrel diameter and length, strip material and thickness, production capacity and factory power supply. A finished-part drawing or sample will help us confirm the suitable tooling.